If this failed I was going to stop the boot and type tpl to get into the bootloader but as noted in the openwrt wiki the update by tftp by direct command is the most dangerous and with these serial flash chips and no way to repair a bootloader without removing the chip. although it is obviously only useful if the firmware is running and has the USB mount setup already. I am a bit surprised people don't use the USB method more often. easy peasy.Īll this is based on all the excellent work in the openwrt wiki. Once back to TP-Link OEM firmware, I flashed to Gargoyle again using the factory update. So in the end this was actually fairly easy to do.Ĥ. This is able to flash without caring about the version. In this case it failed because the guy flashed a v3 firmware to a v2 WR1043ND and so the names don't match. Go to the directory with the cd the sysupgrade command. this is tricky part to find where it mounted.įilesystem Size Used Available Use% Mounted on Find the USB file in console of the router. Went back to the original TP-Link firmware which always seem to be a good idea.Ĥ. do not use for anything else.īut it is easy to cut the header off as well. There is a download in the openwrt wiki to help you. (you need to use a noboot or header removed firmware) With no ethernet and no wireless how to get the firmware in. it is clear the error was a switch driver because the ifconfig in the console gives all the right values. boot the router so you can see the boot messages. Plug into computer using a suitable TTL-Serial cable. only the ground one is slow to heat up sufficient area.Ģ. Pinouts and soldering were easy as the holes are not filled with solder. just took me a long time to work out all the commands. Solution was easy (at least I have done worse). no recovery state.Īll attempts at recovery without soldering were attempted and failed. though in console the port is aware of the connection. The result was no ethernet at all, no wireless. This is a v2 that was flashed to v3 firmware. Since I have really enjoyed Gargoyle for almost as long as it has been around. Just thought I should contribute something to the forum here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |